SM-SX100
– 22 –
Figure 22-1
Figure 22-2
Bundle the core wound on the lead line of AC inlet into the
hole of the shown hole with the nylon band.
When bundling, put the head of the nylon band in the set.
The core mounting direction is as shown.
After bundling, insert CNS501 into CNP501.
(CNP501)
Nylon Band
Check the line process.
The cored lead line soldered on the AC Inlet
is processed as specified.
Pass the ground line of AC Inlet
through the edge side, and
bundle it in the shown direction.
Edge Saddle
As shown, route the lead line under POWER
SW and through the front edge saddle, and
project it on the chassis side. Also retain the
long lead line at 4 places and the short one at
2 places with the clamper. Pass the short one
through the center saddle.
Pass three kinds of the shown lead lines
(CNS902, CNS906 and CNS905) through the
edge saddle from the front panel to the outside.
Check the line process.
The lead line soldered on POWER-SW is processed as specified.
Edge Saddle
CNS902
CNS906
CNS905