Sharp R-211A, Руководство по обслуживанию

Страница: 17 / 28

R-211A
15
Figure C-4(a). Power Supply Cord Replacement
Figure C-4 (b) Power Supply Cord Replacement
CONTROL PANEL ASSEMBLY AND SWITCH LEVER REMOVAL
1. CARRY OUT 3D CHECKS.
2. Disconnect the leads from the timer motor.
3. Remove the one (1) screw holding the chassis support
to the front plate of the oven cavity.
4. Remove the chassis support from the oven.
5. Lift up the control panel and release it from the oven
cavity.
6. Now, the control panel assembly is free.
7. Open the door. Remove the switch lever from the front
plate of the oven cavity.
Removal
1. Disconnect the oven from the power supply.
2. Remove the turntable and turntable support from the
oven cavity.
3. Turn the oven over.
4. Cut the four (4) bridges holding the turntable motor
cover to the bottom plate with the cutting pliers as
shown in Figure C-5.
CAUTION: DO NOT DROP THE TURNTABLE MOTOR
COVER INTO THE OVEN AFTER CUTTING
THE BRIDGES. BECAUSE IT WILL DAM-
AGE THE WIRE LEADS OF THE MOTOR
AND IT IS DIFFICULT TO REMOVE IT OUT
OF THE OVEN.
5. Remove the turntable motor cover from the bottom
plate.
6. Disconnect the wire leads from the turntable motor.
7. Remove the single (1) screw holding the turntable
motor to the oven cavity.
8. Remove the turntable motor from the oven cavity.
TURNTABLE MOTOR REPLACEMENT
9. Remove the O-ring and washer from the turntable
motor.
10.Now, the turntable motor is free.
Re-install
1. Remove the any sharp edges on the turntable motor
cover and the bottom plate with the cutting pliers.
2. Re-install the O-ring.
3. Apply the grease (Shinetsu silicone grease G-420 of
Sinetsu Chemical Co. Ltd. or Toray Silicone grease
SH-14 of Toray Silicone Co., Ltd.) to the O-ring and the
base of the turntable motor shaft as shown in Figure C-
6.
4. Re-install the turntable motor with the O-ring and
washer to the oven cavity with the single (1) screw.
5. Re-connect the wire leads to the turntable motor.
6. Insert the tab of the turntable motor cover into the hole
of the bottom plate as shown in Figure C-5.
7. Re-install the turntable motor cover to the bottom plate
with one (1) screw XHTSD40P08RV0 or
XFPSD40P08K00 as shown in Figure C-5.
Cutting pliers
Bridges
Bridges
Turntable motor
cover
XHTSD40P08RV0
or
XFPSD40P08K00
Tab
Hole
Bottom plate
Screw:
Washer
O-ring
Base of turntable
motor shaft
Turntable motor
O-ring
Washer
Apply grease here
Figure C-5. Turntable Motor Cover
Figure C-6. Washer and O-ring Installation and
Grease Applying.
Oven Cavity
Power Supply
Cord
Brown Wire
Fuse Holder
Blue Wire
Green/ Yellow
Wire
Square Hole
Moulding
Cord Stopper
Oven Cavity
Back Plate
Power Supply
Cord
15 mm
Connector CE-230
Blue wire lead of
power supply cord
Wire lead of the
main wire harness