Sharp PG-D100U, Руководство по эксплуатации

Страница: 22 / 38

E-22
For viewing the
picture from a
video source
connected to:
VIDEO INPUT or
S-VIDEO INPUT
7. Select input
Press the INPUT SELECT button to switch the picture
input. When you press the button, the current input mode
is displayed for about 4 seconds. If you press the button
again while the input mode is displayed, the mode
changes as shown on the left.
Confirm the selected input terminal and press the INPUT
SELECT button.
Notes:
•
This can be selected directly using the VIDEO and DATA
buttons on the remote control.
•
In VIDEO mode, the system being received will be indicated
below the “VIDEO” display.
•
When selecting RGB mode, the resolution being displayed will
be indicated under “RGB,” as shown on the left. (Refer to the
second example when connecting to Mac display.)
•
When no signals are being received, “NO SIGNAL” will be
displayed. When receiving a signal the projector is not preset
to receive, “NOT REG.” will be displayed. (This display
function does not operate in Video mode.)
8. Adjust the volume
Press the VOLUME UP-DOWN buttons on the projector
or on the remote control to adjust the volume.
MUTE
•
Press the MUTE button to temporarily turn off the
sound.
•
Press the MUTE button once again to turn the sound
back on.
9. To turn off the power from the projector
or remote control
The power can be temporarily turned off by pressing the
POWER ON/OFF button on either the projector or remote
control.
The POWER indicator will turn red and the cooling fan
will run for 90 seconds, then the power will turn off,
and the projector will return to STANDBY mode.
The power can be turned on again either from the
projector or remote control. When the power is turned
on, the POWER indicator and LAMP REPLACEMENT
indicator light green.
Note:
•
When the MAIN POWER is off on the projector set, the power
cannot be turned on from the remote control.
VIDEO
•
RGB
1024 × 768
RGB
1024
×
768
RGB
800
×
600
RGB
640 × 480
35 KHz
RGB
640 × 480
34.97 KHz
RGB
832 × 624
N T S C
6 0 H z 6 0 H z
6 0 H z
Mac
V O L U M E
3 8
The number of displayed segments
(0~60) increases or decreases as
the volume is raised or lowered.
POWER
LAMP
TEMP.
On-Screen Display
COMPUTER RGB