Sharp PG-C20XE - Notevision SXGA LCD Projector, Руководство по эксплуатации

Страница: 15 / 55

Setup & Connections
12
Connecting the Power Cord
Plug the supplied power cord into the AC socket on the back of the projector.
Power cord
Connecting the Projector
CAUTION
• Make sure you connect the power cord firmly into the AC socket.
• The configuration of wall outlets differs from country to country. Use the power cord that corresponds to the wall outlet in your
country.
COMPUTER COMPUTER AUDIO AUDIO
OUTPUT
(INPUT 1)
INPUT 1 RS-232C
Connecting the Projector to a Computer
You can connect your projector to a computer for projection of full colour computer images.
Connecting a computer using the standard 15-pin input
1
Connect one end of the supplied computer RGB cable
to the COMPUTER INPUT 1 port on the projector.
2
Connect the other end to the Monitor output port on the
computer. Secure the connectors by tightening the
thumb screws.
3
To use the built-in audio system, connect one end of
the supplied computer audio cable to the AUDIO INPUT
1 terminal on the projector.
4
Connect the other end to the Audio output terminal on
the computer.
CAUTION
• Before connecting, be sure to turn both the projector and the
computer off. After making all connections, turn the projector
on first. The computer should always be turned on last.
• Please read the computer’s operation manual carefully.
• Refer to page 47 “Computer Compatibility Chart” for a list of
computer signals compatible with the projector. Use with
computer signals other than those listed may cause some of
the functions not to work.
• A Macintosh adaptor may be required for use with some
Macintosh computers. Contact your nearest Sharp Authorised
LCD Projector Dealer or Service Centre.
Computer audio cable
Computer RGB cable