SIM02E-005B
5
Annex
(normative)
【Test load】
【Design load】
Table.A1-1 Test load using clamps on long frames (see Fig. A1)
Table.A1 Design load using clamps on long frames (see Fig. A1)
clamp center position
clamp center position
(e: mm)
downward force
upward force
(e: mm)
downward force
upward force
240 ＜ e ＜335
5,400Pa
3,600Pa
240 ＜ e ＜335
3,600Pa
2,400Pa
0 ＜ e ＜441
2,400Pa
2,400Pa
0 ＜ e ＜441
1,600Pa
1,600Pa
Table.A2-1 Test load using clamps on short frames (see Fig. A2)
Table.A2 Design load using clamps on short frames (see Fig. A2)
clamp center position
clamp center position
(e: mm)
downward force
upward force
(e: mm)
downward force
upward force
0＜ e ＜262
1,800Pa*
1,800Pa*
0＜ e ＜262
1,200Pa
1,200Pa
Table.A3-1 Test load using Bolt Holes (see Fig. A3,A3-1)
Table.A3 Design load using Bolt Holes (see Fig. A3,A3-1)
bolts & nuts
bolts & nuts
(position of using holes)
downward force
upward force
(position of using holes)
downward force
upward force
4points at "a" holes
5,400Pa
3,600Pa
4points at "a" holes
3,600Pa
2,400Pa
Table.B-1 Test load using clamps on long & short frames (see Fig. B)
Table.B Design load using clamps on long & short frames (see Fig. B)
clamp center position
clamp center position
(L, S: mm)
downward force
upward force
(L, S: mm)
downward force
upward force
0＜ L ＜441 , 0＜ S ＜262
1,800Pa*
1,800Pa*
0＜ L ＜441 , 0＜ S ＜262
1,200Pa
1,200Pa
The Test load has been calculated with a safety factor of 1.5 from the design load.
* Test procedure according to IEC 61215-2:2016. The test results are based on internal evaluation.
test load according to IEC61215
design load according to IEC61215
test load according to IEC61215
design load according to IEC61215
design load according
design load according
test load according to IEC61215
design load according to IEC61215
1. Spring washer 2. Washer
Material: Stainless steel
Material: Stainless steel
Diameter: M8 8.2/15.4mm
Diameter: M8 8.5/15.5mm
Thickness: 2 mm (reference value)
Thickness: 1.6 mm (reference value)
3. Bolt 4. Nut
Material: Stainless steel Material: Stainless steel
Size: M8 Size: M8
Diameter: M8 x 20mm
Fig. A3-1 : The components for BOLT & NUT
