E-10
To turn off the power:
Press the
■
/:OFF button whilst in the stop
mode.
●
After the track number has been written
on the disc, the power will shut off auto-
matically. (For details about the TOC,
see page 19.)
To remove the MiniDisc:
Turn off the power and move the OPEN
lever in the direction indicated by the arrow.
Recordings can not be made in the
following situations:
●
Recording on a playback-only
MiniDisc (commercially available
music).
●
If a MiniDisc is protected against ac-
cidental erasure. (page 8)
About the recording level:
●
If the recording level is too low, the
playback sound volume may be too
low to hear well. If it is too high, the
playback sound may be greatly dis-
torted. Since digitally recorded CDs
have a large dynamic range (the vol-
ume can vary tremendously from very
soft to extremely loud), do not set the
recording level any higher than is
necessary.
Precautions when recording:
●
Do not jar or bump the main unit whilst
recording. Otherwise, the recording
may be unusable.
●
Depending on the strength and type
of playback signal in the original re-
cording, the new recording may not
begin or pause at the correct point
when in the synchro mode. If this hap-
pens, try making a manual recording.
Precautions when inserting a
MiniDisc:
●
To insert a MiniDisc, push on the
middle of the edge of the disc whilst
holding it parallel to the main unit.
●
If any resistance is felt, do not try to
force the MiniDisc into the unit, as it
may cause damage to the unit. If re-
sistance is felt, remove the MiniDisc
and try reloading it.
■
Recording from a tuner or a CD
(Manual recording)
Manual recordings can be started and
stopped as you like.
1
Place the unit in the recording stand-by
mode. (Perform steps 1 - 4 in the “Syn-
chro recording” section.)
2
Press the
06
button.
●
Recording will start.
●
To record from a CD, press the
06
button, and then start playback on the
equipment connected to this unit.
●
Track numbers can be created whilst
recording. (Page 16)
To interrupt recording:
Press the
06
button whilst recording.
●
The unit will enter the recording stand-
by mode.
●
To resume recording, press the
06
but-
ton again.
The track number will be increased by
one each time you interrupt a record-
ing.
2
1
OPEN
* MT15H FOR SEEG(E01-E19)
1999.05.07, 9:00
11