Sharp KC-G41R, Руководство по эксплуатации

Страница: 27 / 28

E-13
1. Remove the Back Panel.
2. Remove the sensor filter.
3. If the sensor filter is very dirty, wash
it with water and dry it thoroughly.
1. Add a small amount of kitchen
detergent to water and soak for
about 10 minutes.
2. Rinse off the kitchen detergent with
clean water.
3. Completely dry the filter in a
wellventilated area.
Clean the inside of
the Water Tank with
a soft sponge and
the Tank Cap with
a cotton swab or
toothbrush.
CARE AND MAINTENANCE
1
4
2
3
5
2
Place Ref.
1
Water Tank
E-13
2
Unit / Back Panel (Pre Filter)
3
Sensors
4
Humidifying Filter
E-14
Humidifying Tray
5
HEPA Filter
E-15
Deodorizing Filter
The filter reset Indicator light will turn on after approximately
720 hours operating. (30 days × 24 hours =720 hours)
This is a reminder to perform the maintenance described
below. After performing maintenance, reset the Filter
Indicator.
Do not apply excessive pressure
when scrubbing the back panel.
RESET
Rinse the inside
with water.
Wipe with a dry, soft cloth.
Remove the dust gently with
a cleaning tool such as a
vacuum cleaner.
NOTE
NOTE
How to clean hard to remove dirt.
How to clean hard to remove dirt.
Tank Cap
Toothbrush
Sensors
Back Panel
(Pre Filter)
Sensor Filter
CAUTION
Back Panel
Sensor Filter
FILTER INDICATOR
CARE INDEX
WATER TANK
UNIT / BACK PANEL
more
3 sec.
ENG
LI
SH
E-14
2
1
After maintenance, correctly
reattach the parts.
Remove the Humidifying Tray Cover.
Rinse with plenty of water.
Rinse with plenty of water.
Reattach the Humidifying Tray Cover.
NOTE
How to clean hard to remove dirt.
Kitchen detergent
(only Humidifying tray)
Citric acid
(available at some drugstores)
100% bottled lemon juice
with no pulp
1
1. Fill the tray half-way with water.
2. Add a small amount of kitchen
detergent.
2 1/2 cups of
water
3 teaspoons
3 cups of
water
1/4 cup
2
Soak for
30 minutes.
Soak for 30 minutes.
(When using lemon juice as your
descaling solution, allow for more
soak time.)
3
Rinse off the kitchen detergent or the descaling solution with clean water.
1
2
2
1
1
2
3
•
Do not remove the Float and the Tray Panel. If they
come off, refer to E-15.
2
1
HOW TO REMOVE THE
HUMIDIFYING FILTER
AND TRAY.
HOW TO ATTACH THE
HUMIDIFYING FILTER
AND TRAY.
Gray White
NOTE
2
1
If you remove the Humidifying Filter shaft,
be sure to reattach it to its original position.
Tray Cover
Click
Click
HUMIDIFYING FILTER AND TRAY
Humidifying Filter Humidifying Tray