en-17
en-18
KN-H24VNA
KN-H24VNA
Place your fingers in the hollow section
and remove.
Steam vent cover
Clean both sides.
Cleaning tips
Removing the unit
CARE AND CLEANING
continued
Inner lid
Remove the stirring unit (see page en-19)
Then push the lever outwards, then the inner
lid will open.
Place the two extensions in their respective
slots, with the text "FRONT" facing out.
Pull diagonally to free the inner lid.
Close the lever to attach the lid.
Gasket
❶
❶
❷
❷
"FRONT" is written here
How to attach
Removing the unit
Lever
Lever
Remove any water
from inside the gasket
Click
Lightly open
the gasket to
wash it.
Cleaning tips
Carefully dry the lid before attaching it after
cleaning. Be careful especially with the gasket
in the middle. Small amount of water may cause
rust.
Refer to
Cleaning tips of the inner pot
if you
encounter difficult to remove dirt.
See page en-16.
If you accidentally removed the
gasket (the rubber-like part)
●
Make sure that the "FRONT" on the
inner lid and the "FRONT" on the gasket
are facing the same way.
(Attach the gasket by folding it, placing it
inside the hole and then letting it open)
A wrong installation may cause the
control panel to fog up. Also it may cause
the Stirrer unit becomes hard to rotate
and the parts break. (The fog on the
control panel will be gone away after a
while.)
●
Clean after every use.
●
Wash with mild soap or detergent solution using a soft sponge.
Rinse and dry thoroughly.
●
Do not remove the gaskets (the rubber-like part)
Back
●
Clean after every use.
●
Wash with mild soap or detergent
solution using a soft sponge.
Rinse and dry thoroughly.
Insert the projection of the steam vent cover
into the hole of the lid.
How to attach
Projection
(KN-H24VNA).indb 17
2017/02/24 16:03:24
