Messages and Signals
148
Messages and Signals
Display messages
Note:
If you have turned on the Caller ID function, see Caller ID in Chapter 7 for
display messages related to Caller ID.
A.M. OFF HOOK
When the fax is in A.M. reception mode, this message
appears when the handset of an answering machine (or
extension phone) connected to the fax has been lifted.
CHECK PAPER SIZE
An incorrect size of paper has been loaded in the paper
tray. Remove the paper and load A4-size paper.
COVER OPEN
The print compartment cover. Close it.
DOCUMENT JAMMED
The original document is jammed. See the following
section,
Clearing Paper Jams
.
FAX RX IN MEMORY
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. After you fix the
problem, press the
START
key to print out the fax.
FILM END
The imaging film may need replacement. Check the film
and replace if necessary.
FUNCTION MODE
The
FUNCTION
key has been pressed.
LINE ERROR
Transmission or reception was not successful. Press the
STOP
key to clear the message and then try again. If
the error persists, see
Line Error
on page 143.
MEMORY IS FULL
The memory is full. This may occur during fax reception
if too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional message
will indicate the problem), resolve the problem so that
printing can continue (see
Substitute Reception to
Memory
on page 104). If you are attempting to transmit
from memory, see
If the memory becomes full
on page
128.