EN
Alarm functionality
Set an alarm
Note:
Check that the radio is displaying the
correct time and date before you set an alarm.
DAB+
Full Scan
Manual Tune
System
DRC
Sleep
Alarm
Prune
Alarm
Alarm 1 Setup
System
Time
Alarm 2 Setup
Backlight
FM
Scan setting
Language
AMS
Factory reset
System
Software Version
BT
System
Alarm 1 or 2 settings
Time
Hour
Min
Duration
1, 5, 15, 30, or 60 minutes
Source
Buzzer, DAB, or FM
Frequency
Daily, once, weekdays or weekends
Volume level
25%-100%
Alarm
On or Off
Note:
If the time is not set or has failed to update
from the radio signal, <
Time is not set
> will be
displayed when you try to set the alarm. The radio
will then prompt you to set the time. An alarm can
only be set after the time has been set.
Stop, snooze or switching the
alarm off
To stop the alarm, short press
,<
Alarm
off
> will be displayed. The alarm symbol will
remain in the display and will sound again at
the same time the next day unless it was set for
<
Once
>.
To snooze the alarm, press
. <
Snooze
> will be
displayed, followed by a 10-minute countdown.
Once the countdown ends, the alarm will sound
again. You can terminate snooze by pressing
.
<
Alarm off
> will be displayed.
To switch off the alarm, follow the steps for ‘Set an
alarm’ and select <
Off
>.
Sleep timer
You can set your radio to switch to standby mode
automatically using the sleep timer. You can
choose from <
Sleep off
>, <
15
>, <
30
>, <
45
>,
<
60
> and <
90
> minutes. To do this, long press
. Use
to scroll and select <
System
>
/ <
Sleep
>. Use
to scroll and select your
preference. <
Sleep
> will be displayed. In the top
right of the radio display, the number of minutes
until your radio will switch to standby mode will
be displayed e.g., S90.
Display backlight timeout
To adjust the display backlight timeout, long
press
. Use
to scroll to and select
<
System
> / <
Backlight
> / <
Timeout
>. Scroll
through the available backlight timeout options.