4
OVEN DIAGRAM
8. Waveguide cover (Do not remove)
9. Touch control panel (See page 5)
10. Liquid crystal display
11. Ventilation openings
12. Power supply cord
13. Turntable
14. Roller stay
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Coupling
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity,
(do not remove the waveguide cover)
, and the feature sticker
from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door, damaged
door seals around the door or dents inside the oven cavity or on the door. If there is any damage, please do not
operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP and repaired, if
necessary.
2. Accessories provided
1) Turntable
2) Roller stay
3) Operation manual and Cooking guide
3. Place the roller stay in the coupling on the oven fl oor, then place the turntable on to the roller stay, ensuring it is
located fi rmly. Refer to OVEN DIAGRAM below. NEVER operate the oven without the roller stay and turntable.
4. This oven is designed to be used on a countertop or in a cabinet. It should not be installed in any area where
excessive heat and steam are generated, for example, next to a conventional oven unit. The oven should be
installed so as not to block ventilation openings. Allow a space of at least 10cm on the top, 5cm on both sides and
at the rear of the oven for adequate air circulation. When installing in a cabinet, the minimum inside dimension of
the cabinet should be 560mm (W) x 375mm (H) x 418mm (D). This oven is not designed for built-in installation.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal
injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
R-290N(S) [01-15].indd 4
R-290N(S) [01-15].indd 4
1/14/09 2:45:45 PM
1/14/09 2:45:45 PM
