Sharp BD-AMS10A, Руководство по эксплуатации

Страница: 61 / 72

59
Appendix
Troubleshooting
To Reset this Player
• If this player receives strong interference from a source such as excessive static electricity, strong external noise, malfunction of power supply, or
voltage caused by lightning during use or a wrong operation is sent to the player, errors like the player not accepting an operation may occur.
Press and hold
a/;
on the player until “ ” appears on the front panel display when the player does not operate properly even after the
power has been turned off. Then, after the
a/;
(On/Standby) indicator is lit, turn on the power.
a/;
• When a reset is performed while the power is on, the player will turn off. Turn the power on again. At this point, it may take a few moments for the system processing to finish before
the player is ready for use. During the system processing, the BD/DVD/CD mode indicator on the front panel display of the player will blink. Once the system processing has finished,
the indicator will finish blinking and then light up normally. You can operate the player when the BD/DVD/CD mode indicator is lit.
• Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must be set again.
• When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the problem, contact the nearest service centre approved by
SHARP.
On-screen Error Messages
The following messages appear on the TV screen in case of an error during operation.
Error message Possible Error Suggested Solution
Cannot play. • The disc cannot be played back with this player. • Check the disc, and load it correctly.
Incompatible disc. • If you load a disc which cannot be played with this
player (i.e. a scratched disc), or if you load a disc upside
down, this message will appear, and the disc tray will
automatically pop out.
• Occurs if the loaded disc cannot be played because it is
a non-standard disc or scratched, etc.
• Remove the disc.
Cannot operate. • Occurs if an operation is incorrect. —
This USB memory is not formatted properly. Please format
the memory in USB memory management. • Occurs if there is a formatting error.
• Occurs if the USB memory is not formatted with FAT
32/16.
• Format the USB memory again.
• Format the USB memory with your PC.
The Connected USB Memory cannot be used. It should be
compliant with USB 2.0 • Occurs if USB memory not compliant with USB 2.0 High
Speed (480 Mbps) is used (i.e. USB 1.0/USB 1.1).
• Connect USB 2.0 High Speed (480 Mbps) compliant
USB memory.
NOTE
Cinavia Notice
• This product uses Cinavia technology to limit the use of unauthorised copies of some commercially-produced film and videos and their soundtracks. When a prohibited use of an
unauthorised copy is detected, a message will be displayed and playback or copying will be interrupted.
• More information about Cinavia technology is provided at the Cinavia Online Consumer Information Centre at http://www.cinavia.com. To request additional information about Cinavia
by mail, send a postcard with your mailing address to: Cinavia Consumer Information Centre, P.O. Box 86851, San Diego, CA, 92138, USA.
BD-AMS10A̲EN.indd 59 BD-AMS10A̲EN.indd 59 2012/03/22 16:00:09 2012/03/22 16:00:09