AR-EB7
UNPACKING AND INSTALLATION
– 4 –
[3] UNPACKING AND INSTALLATION
1. Unpacking
<Before installation>
For improvement of workability, any part of the description in this
manual may be modified without prior notice. In this case, refer to
the service manual.
2. Parts included
3. Installation procedure
Turn the main switch of the copier to the "OFF" position and then
remove the power plug of the copier from the power supply outlet.
1) Remove the rear cover.
Remove the screw, push the portion indicated by the arrow to
unlock the rear cover, and slide the cover to the right to remove it.
2) Cut out the cut-out portion of the rear cover.
Cut out the cut-out portion with nippers or the like.
At this time, be careful about the orientation of the nippers so that
the cut plane of the rear cover is flat.
3) Attach the IMC2 PWB.
Fit the two pawls on the rear surface of the IMC2 PWB frame to the
mounting portions of the copier and secure the PWB with the four
supplied golden screws M3 x 6.
IMC2 PWB (with frame)
screw (golden) M3 x 6: 4pcs.
Installation manual: 1 volume
Pawl for
locking
Rear cover
Screw
Cut-out portion
Rear cover
Pawl
Screws (golden)
M3 x 6
Pawl
IMC2 PWB
Screws (golden)
M3 x 6
Take care not to get
the cable caught.