24
Programming recording (for logged in recorder)
You prepare the station marked with the
buttons for recording by
pressing the
red
button. In the following menu you con
fi
rm the timer
data or change them as required. Then a red dot is set in front of this
programme in the EPG programme list as an identi
fi
cation. If you select
this programme, you can delete the programme from the timer again
with the
red
button.
You can record a digitally transmitted programme and watch an analogue
programme at the same time or vice versa
✳
.
Note
: Never select the sound format “Dolby Digital” during recording,
even if this is provided, since it cannot be recorded.
Call EPG menu:
Note
: not with DVB-T stations in UK.
Call EPG menu
EPG menu
Select provider
Station selection
AVL timer list
Data capture
on (for DVB + analog)
You will
fi
nd the following settings in the EPG menu:
• “Select provider” • “Station selection” • “AVL timer list
• “Data capture”
Selection of provider/station
In case of analogue TV programmes, you can change the provider (the
station which transmits EPG data) to get EPG content for other pro-
grammes. You can do this under “Select provider”.
Select “Select provider” and call this menu with
OK
. If the station you
want to change to is not listed in the “Select provider” list, start the
provider search with the
green
button. This takes a while.
Or, if you know the station, press the
yellow
button for “Change provider
list”. Select the provider in the programme list and enter it with
OK
and
return to the provider selection with
BACK
.
Select the provider in the “Select provider” menu and press
OK
. Then a
programme range search is performed. The programmes offered by the
provider are displayed in a list.
If you want certain programmes to be omitted from the programme
guide, you can select and deactivate these in the "Station selection". Call
the programme selection with
OK
. Now all programmes are displayed
(the DVB programmes too). Programmes marked by “E” are analogue
terrestrial/cable programmes, programmes marked by “D” are digital
programmes ready for the programme guide. Select the programmes
you want to omit from the programme guide one after another and
deactivate each one with
OK
.
Data entry
After these settings or every time the switch is set off with the main
switch, the data must
fi
rst be collected (only for analogue TV). To do
this, select the programme which you have de
fi
ned as a provider and
leave it switched on for about 1 hour or switch the set to standby. After
about 2 minutes the mode indicator on the TV set lights orange. The
data entry begins and lasts about 1 hour. The data are also automatically
collected between 2 and 5 in the morning when the TV is switched to
standby.
A prerequisite for data entry is that “Data capture” is “on (for DVB +
analog)” in the EPG menu.
Note
: If the main plug is pulled out or the
ON/OFF
-button is pushed, all
EPG data are lost.
If you cannot receive any EPG providers, for example, you should switch
off the data entry.
Switch on TV when marked
You can have the TV switched on automatically from standby at the be-
ginning of the memorised programme. If you are not present at the time,
a safety prompt makes sure the TV switches off again after 5 minutes.
Modes of operation
Содержание Aquos LC-26GD7E
Страница 42: ...SHARP CORPORATION 233 32414 003 ...