E-4
Use the weight with
the string used in
Step 1 to make sure
the bracket is
perpendicular.
Installing the based bracket to the wall
Determine the location where the based bracket will be installed.
Take the coin with the string and align it perpendicular to the based bracket.
Use the V-shaped notches of the bracket in the vertical position to check the horizontal
offset of the based bracket.
Use a pencil, etc., to mark the two screw hole locations.
Loosely screw in the screws.
Temporarily remove the based bracket from the wall and loosely screw in 2 off-the-shelf
screws in the screw hole positions marked on the wall. At this time, the screw heads should
extend several mm above the wall so that the based bracket can be hung on the screw
heads. Hang the based bracket on the installed screws, check to make sure the bracket is
not sagging to the left or right, and then firmly tighten the screws. Use off-the-shelf screws
to secure the remaining screw holes (14 to 18 screws).
*Use a screw with a screw head height of 8.5 mm or less.
Cellophane tape, etc.
shaped screw
holes
Use a pencil, etc., to
mark the screw hole
position on the wall
behind the bracket.
Align horizontally and vertically until
the string lies on top of the vertical
reference line (V-shaped notch).
V-shaped notch
Layout line
Align this with the center
of the television screen.
V-shaped notch
1
2
Included part: Based braclet
Included part: Based braclet
Max. 8.5mm
Min. 4mm
Wall
Содержание AN-52AG1
