E-3
INSTALLATION INSTRUCTIONS
WARNING
:
Turn off and disconnect the unit before working.
INSTALLATION
1
2
(1)
Angle
Chassis
Wrench
Fig.3
Front panel
Fig.2
Fig.1
Remove the front panel by pulling the
front panel at the lower corners towards
you about 3 cm (1" ). Next lift it up and
pull it towards you.
(Fig.1)
Cabinet
ENGLISH
Unscrew the 2 stopper screws at the
back of the cabinet (Fig.2).
Unscrew the stopper screw from the
angle at the front of the chassis.
Keep the screw and angle as they
will be used later in Step 6.
Slide the chassis out from the cabinet
by pulling on the hand hold located
at the bottom center of the chassis.
(Fig.2)
(2)
(3)
3
Remove the 3 fixing nuts and the fixing
angles from the compressor.(Fig.3)
Some models may not be equipped
with the fixing angles. These are for the
purpose of transportation only. Keep
them in a handy place in case of re-
location.
Fixing nut
Fixing angle
Rubber
Compressor
3 positions
