Sharp 14VT10X1, Руководство по обслуживанию

Страница: 13 / 138

REPLACEMENT OF LOCK RELEASE LEVER
1.
2.
Removal
Place the slider in the cassette down position.
(Turn the coupling on the worm shaft clockwise
until the slider is in the cassette down position.)
Note: Before shifting, unlock the slider.
Slightly widen the cassette housing frames
and
to unhook the slider holders and of
the slider assembly off the grooves of the
cassette housing frames.
Cassette housing
f r a m e
Cassette
Slider holder
Slider holder
Figure
3. Lift the slider holder upward about 2mm off
the slider by pressing two catches with a thin tip
screw driver. Take care not to damage the
catches.
lock catch
holder
it upward
about 2 mm.
Lock release lever
Lock release lever
Figure
4.
l
1 .
2.
3.
4.
5.
Remove the lock release lever
holder(R) from the slider
Reassembly
Follow the steps for removal tne reverse order.
(See Figures
and l-18.)
Attach the lock release lever to the slider holder
Slide the slider holder downward so that the
two catches of the slider holder (R) fit the
opening of the slider.
Slightly widen the cassette housing frames, and
set the pins of slider holders
and into the
grooves of the cassette housing frames.
Note: Check if the pins of the slider holders (R)
and fit the grooves of the cassette
housing frames, and if the drive gear arm
is sufficiently engaged with the slider
holders.
Turn the coupling counterclockwise until the
slider is at the cassette insertion opening.
TO RUN A TAPE WITHOUT THE
HOUSING CONTROLASSEMBLY
1. Plug in the power cord.
2. Turn on the power switch.
3. Open the lid
of a cassette tape by hand.
4. Hold the lid with a pair of vinyl tapes
5. Set the cassette tape in the mechanism chassis.
6. Weight the cassette tape with a weight
to
prevent float.
7. Perform running test.
Cassette tape
to prevent
here
float 1500
. . ,
Note:
The weight should not more than 500
Figure l-19.
15