Sharp Shape USB3D, Инструкция по сборке

Страница: 4 / 8

4
Figure 6. The cross-bar and 4 wheels
Figure 7. The outer rod
Figure 8. Attach the outer rod to the cross-bar
Scanner Assembly
Skip this section (except Step 6 and Step 7) in
the case that a customer doesn’t order the
adjustable stand.
Step 1.
Mount the four wheels on the cross bar. Usually,
you do not need a wrench if you can use your
hand to drive the wheels into the cross. It is not
hard. If you can’t, use a wrench to do the work
(shown in Figure 6 on the left).
Step 2.
Mount the outer rod on the cross bar. Note that
the configuration of the rod may have changed.
First, recognize what things are enclosed with
the outer rod. After you have unscrewed the big
nut from the bottom of the outer rod, you will a
spring and an bushing (‘O’ ring) outside the rod
as shown in Figure 7. The black insert is no
longer used.
Second, put the bushing on the rod and insert the
spring inside the rod. Then use the big nut to
mount the rod on the cross bar as shown in
Figure 8. Usually, you do not need a wrench if
you can use your hand to drive the big nut. Use a
big wrench to do the work if you have to.