420 774 335 397 www.sharks-shop.cz
Stránka 30
Before starting work must be dirrection button (8) of rotation in the correct position or may be damaged
drill.
To switch the speed using the direction button back and forth (in the direction right/left,
enable/tightening). Switch the dirrection button switch to the middle position to lock control switch
ON/OFF (blocking launch drills).
5. Torque setting
Your modern cordless drill has torque setting for use correct torque, Total is available 15+1 options.
Turn
the control segment/ring (2) for set the appropriate torque for your working operation (e.g. changing the
depth of screwing).
Before drilling set the ring on "drilling" because will be provided the highest torque.
NOTE: Adjustment (change) torque can be performed only when cordless drill not running.
Otherwise
threaten machine damage.
In practice:
Setting for tightening screw on the lowest available torque value if will turn over control segment moment
to the arrow "1". Drilling with drill slight resistance in this position. Conversely the higher the value the
higher the torque.
RECOMMENNDATION: Set the correct torque before each operation (to prevent damage to the heads
of the screws and drills). Always start with the lowest torque and increase according to the needs and
demands of working operations.
Orientation chart torque:
1 - 5
tightening small screws
6 - 10
screwing into soft material, for screws with the smaller diameter
11 - 13
screwing into tougher material, for screws with the larger diameter
14 - 15
screwing into hard material, for screws with the large diameter
6. Speed setting
This cordless drill Sharks has adjustable speed. Change can do with switch "Speed setting"(9). Speed I.
will be activated shift the controller toward to the keyless chuck and Speed II. will activated toward to the
handle.
Speed I. is slow speed (0 – 400 RPM) – for a regime tightening, a higher force, lower speed rotation.
Speed II. Is fast speed (0 – 1500 RPM) – for a regime drilling, a smaller force, higher speed rotation
USING YOUR DRILL
NOTE: Use only working instruments (drills, bits, etc.) which can be safely fixed in keyless chuck and
which are designed for yours working operation.
Pictogram for the process „drilling and screwing“
Pictogram process "hammering"