420 774 335 397 www.sharks-shop.cz
Stránka 29
OPERATION
1. Commissioning
A) Inserting and removing the battery from the Cordless drill
Insert charged Li-Ion battery (6) into the bottom of the handle drills. When inserting the battery do not
use force and be careful for polarity. The process inserting and removing the battery should be smooth
and without resistance. Insertion battery pack into tool until an audible click is heard. Removing battery
pack espress the battery release button(4) and pull battery pack out of tool.
B) Battery charging
The cordless drill Shars has a modern Li-Ion battery with capacity 1500 mAh.
Advantages of this type of battery consist in higher energy concentration,
smaller dimensions and weight.
The cordless drill can keep voltage if is not
fully charged. This model can be recharged in 60 minutes! Li-Ion no memory
effect and consequently does not suffer from self-discharge
(After the first well charged). Fully charge battery before first use. Battery
reaches full power after third to the fourth charge.
IMPORTANT! To charge use the included charger and then the charger
connect to the mains.
Charging will start automatically.
Charging Procedure: When the red lit charging process has begun.
When the red and yellow lit battery is half charged. If the battery is 100%
charged will be lit red, yellow, green and may be used at this time or left
in the charger. Remove the battery longest in one hour. Than remove the
battery from the charger first disconnect from the network.
2. Keyless chuck
•
Working tool insert into the keyless chuck (1) without cran.
•
Before deploying drill set the direction button (8) to the center position -
prevention accidental operation.
•
Turn the sleeve chuck head to the right and open the jaw so that it can be
inserted working tool.
•
Insert the bit or other accessory fully into the chuck, and tighten securely by
holding the rear half of the chuck and rotating the front portion in the clockwise
direction as viewed from the chuck end.
•
Check whether the drill tip or fitted properly (while tightening keyless chuck).
•
Use only straight and undamaged work tools!
3. ON/OFF switch
To turn the tool on, squeeze the trigger switch (4) and for continuous operation or for enable/tightening
hold the button.
The variable speed switch enables you to select the best speed for a particular application. The further
you squeeze the trigger, the faster the tool will operate.
When press the ON/OFF button will automatically launch built-in worklight (3).
To turn the tool off, squeeze the trigger ON/OFF switch.
NOTE: Your tool is equipped with a brake. The chuck will stop when the trigger switch is fully released
and will prevent the destruction of or damage to the screw head.
4. Direction button
IMPORTANT! The center position of the control button locks the tool in the off position.
When changing the position of the control button, be sure the trigger is released.