420 774 335 397 www.sharks-shop.cz Stránka 38
Avoid bouncing and snagging the wheel, especially when working corners, sharp edges etc. This can
cause loss of control and kickback.
NEVER use tool with wood cutting blades and other saw blades. Such blades when used on a grinder
frequently kick and cause loss of control leading to personal injury.
CAUTION:
After operation, always switch off the tool and wait until the wheel has come to a complete stop before
putting the tool down.
Grinding and sanding operation
ALWAYS hold the tool firmly with one hand on housing and the other
on the side handle. Turn the tool on and then apply the wheel or disc
to the work piece.
In general, keep the edge of the wheel or disc at an angle of about 15
degrees to the work piece surface.
During the break-in period with a new wheel, do not work the grinder
in the B direction or it will cut into the work piece. Once the edge of
the wheel has been rounded off by use, the wheel may be worked in
both A and B direction.
Operation with wire cup brush (optional accessory)
CAUTION:
Check operation of the brush by running tool with no load, insuring that no one is in front of or in line
with brush.
Do not use brush that is damaged, or which is out of balance. Use of
damaged brush could increase potential for injury from contact with broken
brush wires.
Unplug tool and place it upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire cup brush onto spindle
and tighten with supplied wrench. When using brush, avoid applying too
much pressure which causes over bending of wires, leading to premature
breakage.
1 - Wire cup brush
Operation with wire wheel brush (optional accessory)
CAUTION:
Check operation of wire wheel brush (1) by running tool with no load, insuring that no one is in front of
or in line with the wire wheel brush.
Do not use wire wheel brush that is damaged, or which is out of balance. Use of damaged wire wheel
brush could increase potential for injury from contact with broken wires.
ALWAYS use guard with wire wheel brushes, assuring diameter of wheel
fits inside guard. Wheel can shatter during use and guard helps to reduce
chances of personal injury.
Unplug tool and place it upside down allowing easy access to spindle.
Remove any accessories on spindle. Thread wire wheel brush onto spindle
and tighten with the wrenches.
When using wire wheel brush, avoid applying too much pressure which
causes over bending of wires, leading to premature breakage.
Operation with abrasive cut-off wheel (optional accessory)
WARNING:
When using an abrasive cut-off wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
NEVER use cut-off wheel for side grinding.
During cutting operations, never change the angle of the
wheel. Placing side pressure on the cut-off wheel (as in
grinding) will cause the wheel to crack and break, causing
serious personal injury.