SharkRF openSPOT3, Руководство пользователя

Страница: 93 / 131

NXDNReflector connector
You can use this connector to connect to a network which supports the NXDNReflector protocol, like
NXDNReflector servers.
The easiest way is to use the Quick setup to connect to these networks.
Talkgroup handling
NXDNReflector servers handle only one talkgroup. You can find each server's talkgroup ID in the server list, or if
you enable Advanced mode, then the talkgroup ID setting will be shown.
If you use NXDN® modem mode, then make sure you send your calls as a group call to the talkgroup ID,
otherwise the server will ignore your calls. Also make sure you have the talkgroup ID in your SelCall list (if
SelCall is enabled), otherwise you won't hear incoming calls on your radio.
If you use cross modes, then send your calls as a group call to the talkgroup ID, otherwise the server will
ignore your calls.
If you use a DMR radio, then make sure the talkgroup ID is set as the TX contact for the current channel in
your radio, or the talkgroup ID is in an RX group list which is assigned to the current channel of your radio,
otherwise you won't hear incoming calls from the server.
You can also set the Default cross mode destination ID to the talkgroup ID and enable Always use this ID
in cross mode . These settings are available on the Settings page, NXDN® settings section. This way your
cross mode calls will be always sent to the correct talkgroup ID.
Switching NXDNReflector servers using your radio
You can switch NXDNReflector servers with your radio by calling the desired server's ID with a private call.
Cross mode usage
The NXDNReflector connector is an NXDN® connector, but it supports DMR, D-STAR®, and C4FM cross modes.
Using a DMR transceiver
You can switch NXDNReflector servers with your DMR transceiver by calling the desired server's ID with a private
call.
Using a D-STAR® transceiver
NXDNReflector
93