sharkclean .com
sharkclean .com
CHARGING
CHARGING
STORAGE ON THE GO
CHARGING WHILE IN STORAGE MODE
CHARGING THE HAND VACUUM
REMOVING THE BATTERY
Charge the unit in upright mode by placing it on the
dock plate, with the hook on the back of the wand
over the charging post. Make sure the contacts
on the wand are aligned with the contacts on the
charging post.
When charging is complete and you need to use
the unit again, lift it off the dock plate.
To charge the hand vacuum without the dock,
unplug the charger cord from the dock and connect
it directly to the port on the hand vacuum, near the
nozzle opening. To detach the hand vacuum, press
the release buttons on both sides of the handle and
lift it off the wand. (See previous page.)
Detach the hand vacuum (see below). Charge the
unit by sliding the hand vacuum nozzle opening
over the post on the storage arm. To charge, make
sure the contacts on the hand vacuum are aligned
with the contacts on the storage arm.
When charging is complete and you need to use
the unit again, reattach the hand vacuum and use it
to lift the wand and nozzle off the dock plate.
To detach the hand vacuum from the wand, press
the release buttons on both sides of the handle and
lift it off the wand.
To reattach the hand vacuum to the wand, align the
nozzle opening over the top of the wand and slide
it on until it clicks into place.
UPRIGHT DOCK CHARGING
CHARGING HAND VACUUM
SIDE-BY-SIDE DOCK CHARGING
HAND VACUUM RELEASE BUTTONS
STORAGE HOOK
CONTACTS
CONTACTS
STORAGE POST
For quick and easy short-term
storage, first attach the wand
storage clip by pressing it onto
the front of the wand.
To remove, slide the hand vacuum
up and out. To remove the storage
clip, pull it off the wand.
Lock the nozzle and wand in
the upright position, and detach
the hand vacuum (see previous
page). Hang the hand vacuum
from the wand storage clip, with
the filter removal latch sitting
inside the clip.
To remove the battery from the hand vacuum,
press the release tabs on the battery cap and slide
out the battery. To reinstall, slide the battery
into the compartment in the handle until it clicks
into place.
BATTERY
NOTE:
When docked properly, the charging lights on
the hand vacuum will blink, indicating that charging has
begun. When charging is complete, all three indicator
lights will remain on for 10 minutes, then shut off.
NOTE:
The main unit comes with a partial charge.
For maximum runtime, charge fully before first use
(approximately 3 hours). Leaving the unit plugged in
will not damage battery life.
