7
OPERATING INSTRUCTIONS
Fig. 9
Fig. 10
2. To release the handle to a comfortable position, apply pressure to the top of the
sweeper head with your foot while pulling back on the handle. To bend the folding
pivot, press the release button on the upper handle while applying a forward
pressure on the handle. The folding pivot will click into a bent position. (Fig. 10)
3. To change the speed of the brush roll, press on the speed control button. Press the
speed control button once for bare floor and twice for carpeted areas.
ANTI-JAM BRUSH ROLL FEATURE
This feature protects your sweeper’s motor from damage due to overheating, that may
be caused by the rotating brush gets jammed. If the rotating brush becomes jammed
the brush will stop turning and the speed indicator light will remain lit. To reset the unit:
1. Press on/off switch.
2. Remove the transparent brush cover from the sweeper power head to remove any
build up of lint, hair or fiber on the rotating brushes.
3. Wait for 10 seconds to allow the unit to cool down.
4. Press on/off switch again, the unit should restart.
On/Off Switch
Handle
Release
Button
HOW TO OPERATE YOUR CORDLESS SWEEPER
NOTE:
Before using, please ensure that the cordless sweeper has been initially
charged for 20 hours.
Your cordless sweeper will only operate properly when the batteries are fully charged.
Your sweeper will operate for varying lengths of time on a full charge. This will depend
upon the type of surface being cleaned. (Longer operating time on bare floors vs.
carpets.)
1. Push the on/off switch to operate the unit. To turn “Off”, press switch again. (Fig. 9)
8
OPERATING INSTRUCTIONS
Fig. 12
Fig. 11
Fig. 13
CLEANING THE DUST CONTAINER
To achieve the best performance, empty the dust container after each use.
1. Pull the dust container straight out from the side. (Fig. 11)
NOTE:
Be careful not to accidentally turn the unit “On” .
2. Empty dust container contents. (Fig. 12) If desired, you may rinse the container
with water to clean the dust container - but dry thoroughly before replacing on the
sweeper.
3. Replace dust container into the cordless sweeper.
4. Periodically remove the transparent brush cover on the front of the cordless
sweeper and remove any build up of lint, hair or fiber around the rotating brush.
To remove the cover - grip the cover from the bottom, pull out and upward until the
cover unlocks from the side slots and tabs located on the top of the sweeper.
Carefully cut away threads or hair with scissors. (Fig. 13)
CAUTION:
Do not accidentally turn unit “On” while cleaning.
Any electronic or electrical appliance should not be stored in
or exposed to areas of high heat or humidity. Do not store
your cordless sweeper close to stoves, radiators, furnaces or
in a bathroom or bathing area
.
