background image

5

www.sharkclean.co.uk

MAXIMIZING THE LIFE OF YOUR 

BATTERY

1

   To enhance battery life, this vacuum 

is equipped with an advanced feature 
that will shut off the vacuum when 
the battery is almost fully discharged. 
If the vacuum shuts off while in use, 
charge the unit until the complete 
oval around the power button is 
illuminated, indicating a full charge.

2

   Charge the vacuum for 6 hours 

before initial use. After initial use, 
each recharge will take 3 to 6 hours. 
A complete oval around the power 
button will illuminate when the charge 
is complete. 

3

   The precision charger monitors the 

batteries so you don’t have to. A 
complete charge can take as little as 
3 hours, but may take up to 6 hours 
because the charger monitors battery 
properties to extend battery life. 
Leaving the unit in the charger past 
the complete charge time will NOT 
harm the batteries.

4

   If the vacuum has never been used 

or has not been used for an extended 
period of time, it will take 3 to 5 
complete charge and run down cycles 
to realize the full operational time of 
the vacuum.

5

   Do not store or charge in areas of high 

temperature or humidity.

6

   Use only the charge adapter supplied 

with this unit, marked with “For 
SV1100UK Models Only”. If other 
chargers are used, the battery can fail 
causing damage to the battery, to the 
vacuum, or to personal property.

USING YOUR SHARK

®

 CORDLESS VACUUM

USE YOUR CORDLESS VACUUM 

TO CLEAN BARE FLOORS, 

CARPETS AND RUGS.

1

   Place your foot lightly on the top 

of the motorised brush and tilt the 
handle back to release the unit 
from the locked upright position. 

 

•  Lightly press the power button 

on the motorised floor brush 
with your foot to turn the 
vacuum on to a high speed 
optImised for carpet cleaning. 

On this setting, the vacuum 
will run for approximately 15 
minutes.

 

•  Press the button again to switch 

to a lower speed optImised 
for bare floor cleaning. On this 
setting the vacuum will run for 
approximately 22 minutes. The 
LED lights around the power 
button will indicate your speed.

 

•  Press the button again to turn 

the unit off.

BATTERY RECONDITIONING 

If you experience shorter run time over the 
life of the vacuum, perform the following 
battery reconditioning steps. These 
steps can also be performed as monthly 
maintenance for maximum battery life.

1

   Charge the vacuum for a minimum of 6 

hours.

2

   Run the vacuum until it turns itself off.

3

   Charge the vacuum for a minimum of 6 

hours.

BATTERY REMOVAL, REPLACEMENT 

AND DISPOSAL

The cordless vacuum is powered by Ni-Mh 
batteries, 

which must be recycled or 

disposed of properly in accordance 
with state, federal and local laws

. If 

uncertain as to how to remove the battery 
pack, we suggest that you take your 
vacuum to a reputable small appliance 
service technician to have this service 
performed. 

BATTERY REMOVAL

1

  Ensure that the unit is Off. 

2

   Never open the battery compartment 

except to replace or dispose of the 
battery pack.

3

   The battery door is on the bottom of 

the floor nozzle. Turn the unit over and 
push the sliding tab located next to the 
battery door to the unlock position. 
Slide and lift the battery door off of the 
nozzle.

4

   Remove the battery pack by pulling on 

the battery strap.

5

   Grasp the white connector terminals 

and push down on the lever with your 
thumb. Pull to disconnect.

BATTERY REPLACEMENT

1

   Push the connector terminals together 

until they click into place.

2

   Replace the new battery pack into the 

battery compartment, taking care to 
tuck the wiring completely in so that 
the wiring does not interfere with the 
battery access door.

3

   Place the battery door onto the bottom 

of the nozzle, slide it back into place 
and move the sliding tab next to the 
door to the lock position.

CAUTION:

•  Use only with battery pack supplied.

•   Never use ordinary batteries for 

replacement as these may leak and 
damage your vacuum

•   Do not attempt to remove the battery 

pack from the unit to charge.

•   Never throw the battery pack or the 

appliance into a fire or incinerate it.

•   Do not remove or damage the battery 

casing.

•   Do not place the batteries on metal 

surfaces.

•   Do not touch metal parts of the 

batteries together as the batteries will 
overheat.

Call customer service at  

FREEPHONE 0800 781 7831 to order 

a replacement battery pack.

 

 IMPORTANT: The indicator light 
around the power button will 
flash if the brush roll stops 
due to a jam. This feature is 
designed to protect the Lifetime 
Belt that powers the brushroll. 
See “Restarting After a Jam” on 
page 8.

BARE FLOOR

CARPET

SV1100UKJR_40_ENG_120124_1.indd   5

12-01-24   10:05 AM

Содержание SV1100UKJR













Отзывы: