Shark SV1100UKJR, Руководство пользователя

Страница: 8 / 12

8
www.sharkclean.co.uk
CARE AND MAINTENANCE - cont.
4 Inspect the rotating brush for
a build-up of debris. Remove
anything wound around the
brush by carefully cutting it
with scissors. The brush roll is
equipped with a raised cutting
guide to make inserting scissors
easier. Avoid damaging or cutting
the bristles. (
fig. 13 )
5
Use a flashlight to inspect inside
the air duct at the bottom of the
main body and remove any debris
or blockages that may be there.
Reattach the motorised brush,
ensuring it clicks into place.
6 Remove the dust cup and use the
flashlight to check the air path
on the spine of the vacuum and
remove any debris or blockages.
Then replace the dust cup.
BRUSH BAR REMOVAL
1 For easier cleaning, the brush roll
can be removed from the nozzle.
Using a coin, turn the dial next to
the brush roll access door to the
unlock position. (
fig. 14 ) Remove
the brush roll access door.
(
fig. 15 )
2 Slip the black belt off of the white
gear and lift out the brush roll.
(
fig. 16 )
BRUSH BAR INSERTION
1 To reinsert the brush roll, first slip
the black belt onto the white gear
(
fig. 17a
), then align the white
square on the opposite side of
the brush roll into the square slot.
(
fig. 17b )
2 Align the white square on the belt
side and position into its slot.
(
fig. 18 )
3 Replace the door, inserting the
wheel side first. Use a coin to
move the dial to the lock position.
RESTARTING AFTER A JAM
If the indicator light around the power
button flashes, the brush bar has
jammed and will cease to operate.
1 Turn the unit off and allow it to
cool down for 10 seconds.
2 Ensure that nothing is blocking
the motorised brush or wrapped
around the brush bar.
3 Turn the power on and the unit
should operate normally.
fig. 14 fig. 15
fig. 16
fig. 17a
fig. 17b
fig. 18
fig. 13
SV1100UKJR_40_ENG_120124_1.indd 8 12-01-24 10:05 AM