Shark STRATOS CLEAN SENSE IQ MultiFLEX IZ800 Series, Руководство пользователя

Страница: 8 / 13

sharkclean.com sharkclean .com
FLOOR NOZZLE
MAINTAINING YOUR VACUUM
CLEANING SOFT ROLLER
FLOOR NOZZLE
If any hair is wrapped around the brushrolls, continue cleaning using the Carpet setting on a
bare floor surface, a low-pile carpet, or a small area rug. If some fibers remain wrapped around
the brushrolls after continued use, carefully remove them. If you run over a hard or sharp object
or notice a change in noise while vacuuming, check the floor nozzle for blockages. (See the
Checking for Blockages in the Floor Nozzle section.)
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld
Vacuum:
1.
Turn off vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings on the dust cup and
remove any debris or blockage.
Checking for Blockages in the Wand:
MultiFLEX® Wand:
1.
Turn off vacuum.
2. Remove the handheld vacuum and floor
nozzle from the wand.
3. Check the Clog Access Hose on the
MultiFLEX section of the wand by
pinching the tabs on both sides of the
hose and lifting the hose out.
4. Clear any debris and blockages.
Checking for Blockages in the Floor Nozzle:
1.
Turn off vacuum.
2. Detach the wand.
3. Use the edge of a coin to open the three
locks on the bottom of the floor nozzle.
4. Remove the cover and tilt back the neck
of the floor nozzle.
5. Check the opening and remove any
debris.
6.
Replace the cover by sliding the inserts
into the slots, then pressing down firmly on
all sides. Turn the locks clockwise to close,
until they click securely into place.
1
To remove Soft Roller from nozzle, pull the
Soft Roller out by the tab.
2 Tap loose debris off the Soft Roller. Use a
dry towel to wipe the Soft Roller clean and
to remove any debris caught in the teeth
behind the Soft Roller.
3 Hand wash the Soft Roller as needed. Use
only water, and let air-dry completely, which
should take at least 24-48 hours.
4 Reinsert Soft Roller until you feel it click into
place.
CLEANING THE SENSORS
Make sure to clean the
sensors inside the hand
vacuum regularly, as hair
and other debris may build
up and obstruct them. If
the sensors are partially obstructed, Clean
Sense IQ mode will not adjust suction levels
as expected. If the sensors are completely
obstructed, the F0 error code will appear and
the Clean Sense IQ icon will flash on the hand
vacuum display panel.
To clean the sensors:
1. Turn off power and remove the hand
vacuum.
2. Locate the sensors inside the nozzle of
the hand vacuum. The sensors are on the
interior walls of the nozzle, about 3 inches
down the air path, aligned with the IQ
logos (Fig.2) on the exterior.
3. Gently wipe the sensors with a microfiber
cloth and remove all hair and debris.
4. Turn on power and verify that the unit is
functioning normally.
IQ logos-
both sides
Fig. 2
CLEAN SENSE IQ SENSORS
Hand Vacuum Display Panel
Dust cup
Air path
Fig. 1
Battery