7
8
CUSTOMER CARE - AU: 1800 890 840
CUSTOMER CARE - NZ: 0800 002 999
NOTE:
Sweep or vacuum your floors prior to cleaning
with your Steam Mop.
Assembling Your Steam Mop - cont’d
IMPORTANT:
Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have been
treated with wax or some no wax floors, the sheen
may be removed by the heat and steam action. It
is always recommended to test an isolated area
of the surface to be cleaned before proceeding.
We recommend that you check the use and care
instructions from the floor manufacturer.
NOTE:
To prolong the life of your Steam Mop, we
recommend using distilled water.
3
Select either the All-Purpose Mop Head or the
Triangle Mop Head and accompanying cleaning
pocket. Use the lavender loop on the side of the
cleaning pocket to slide the mop head into the
pocket. Then secure the quick fasteners on the top
of the pocket to lock in place.
(fig. 3)
4
Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place.
(fig. 4)
5
Turn the water tank cap counter clockwise and
remove from the tank.
(fig. 5)
Use the filling flask and pour water into the tank. Do not
overfill. Replace the cap on the water tank.
(fig. 6)
1
Pull and twist the quick release cord holder to unwrap
the power cord completely. Plug into an electrical
outlet.
(fig. 7)
2
The
ON/STEAM SETTING
button will flash
blue. If the light does not turn on, reference the
troubleshooting section on page 22.
(fig. 8)
IMPORTANT:
Make sure you do not use the mop
without attaching a cleaning pocket and adding
water to the tank first. When you are using the
mop for the first time, it might take longer than the
normal 30 seconds to start steaming.
Using Your Steam Mop
fig. 3
fig. 4
fig. 5
fig. 7
fig. 6
fig. 8
