AU
02 8 8 01 76 6 6
NZ
0 8 0 0 112 6 60
AU
sharkclean .com . au
NZ
sharkclean .co. nz
EMPTYING THE DUST CUP
To remove
Dust Cup
, pull up on the release
button located on the side of dust cup handle.
Tilt dust cup forward, then lift to remove.
To reattach, place the bottom of dust cup
onto the pod and then tilt until it clicks
into place.
Hold the dust cup over the bin and press the
release button to open bottom of dust cup.
To remove collected debris from
Lint Screen
,
lift the tab at the top of the dust cup to
open the lid. Remove debris from lint screen
to clean.
Regularly rinse the filters to maintain your vacuum's suction power.
Rinse filters with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electronic parts.
CLEANING THE FILTERS
IMPORTANT:
DO NOT
use soap when cleaning the filters.
IMPORTANT:
Unplug the power cord before performing any maintenance.
Post-Motor
Filter
Foam
Felt
Filter
Door
RINSE PRE-MOTOR FILTERS
EVERY MONTH
1
Pre-Motor (foam and felt):
With the dust cup removed, take out the
foam and felt filters, and rinse with water. Tap
loose dirt off filters between washes
as needed.
RINSE POST MOTOR FILTER EVERY YEAR
To remove the
Post motor Filter
, first pull the
tab on the bottom of the filter door, then lift
off the door. Press the tab on the side of the
Post motor filter.
To reattach the door, align the top first, then
press in the bottom until it clicks into place.
Clean off any debris on the bristles. Carefully
use scissors within the brushroll groove to cut
away any hair or debris wrapped around the
brushroll.
CLEANING THE BRUSHROLL
DEBRIS WRAPPED
AROUND BRUSHROLL
