13
Your
Shark
®
Lift-Around™
Canister Vac is
equipped with a protective Motor Thermostat. If the mo-
tor should overheat, the thermostat shuts off the power.
To reset the Motor Thermostat:
Press the Power Button to turn the vacuum off.
Unplug the vacuum.
Check for clogged hose or filter; unclog hose and replace
filter. Refer to
Checking for Blockages
.
Wait 45 minutes for vacuum to cool; then plug in the
vacuum.
Press the Power Button to restart the vacuum.
Note: If vacuum still does not start, call 0800 51 41 31..
Resetting the Motor Thermostat
Checking for Blockages
Blockages may cause your vacuum to overheat and
shut down. To prevent this from happening, check
potential blockage areas after heavy use or if you
detect a loss of suction or poor cleaning performance.
1
DUST CUP
Dust Cup may be full. Empty Dust Cup.
2
FILTERS (PRE-MOTOR AND POST MOTOR)
Ensure that both the Pre Motor Filters and the Post
Motor HEPA filter are clean.
3
ACCESSORIES
Check intake openings of all the accessories.
4
CLEANING THE POWER BRUSH
• Turn the Power Brush
over, slide the locking latch
forward and tilt the cover upward to remove.
(
fig. 22
)
• Inspect the rotating bristle brush, turbine wheel
and air passage.
• Remove any blockage or debris and carefully,
without damaging the bristles or belt, cut any
build-up of hair or string wrapped around the
rotating bristle brush with scissors.
• To reassemble, first insert
the tabs on the front
edge of the cover into the
matching holes in the top
half of the Power Brush
and tilt the cover back
down pressing until it
clicks into place. (
fig. 23
)
Locking
Latch
Rotating
Bristle Brush
Turbine
Wheel
Fig. 22
Fig. 23
NP320QUK_40_IB_ENG_130927_3.indd 13
2013-10-03 1:31 PM
