sharkclean .com
sharkclean .com
EMPTYING THE DUST CUP
To remove
Dust Cup
, slide up tabs on both sides
of dust cup handle. Tilt dust cup forward, then
lift to remove.
To reinstall, place bottom of dust cup into
pod and then tilt until it clicks into place.
Press lower release button to open bottom of
dust cup.
To remove collected debris from
Lint Screen
,
press top release button and lift handle to
open. Gently brush debris off the screen.
RINSE HEPA FILTER
EVERY YEAR
Remove dust cup, tilt
Filter Door
and firmly
pull it off. Press tab at top of
HEPA Filter
and
pull out filter. To reinstall, insert HEPA filter
into unit and replace the filter door.
CLEAN PRE-MOTOR FILTERS
EVERY 3 MONTHS
Remove
Dust Cup
, then lift out
Filters
.
Regularly rinse and replace the filters to maintain your vacuum's suction power.
To prevent damage from cleaning chemicals, rinse filters with cold water only. Allow all filters
to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into
electric parts.
CLEANING AND REPLACING THE FILTERS
CLEANING FILTERS
IMPORTANT:
DO NOT
use soap when cleaning the filters.
IMPORTANT:
Unplug the power cord before performing any maintenance. Empty
the dust cup each time you vacuum and periodically during cleaning, when debris
in the dust cup reaches the MAX fill line.
Foam
Felt
Filter
Door
NOTE:
To order replacement parts and filters, visit
sharkaccessories.com
.
Replacement
Pre-Motor Foam &
Felt Filter Kit
XFF350
Replacement
HEPA Filter
XHF350
Follow the previous instructions for removing filters. The
Pre-Motor Filter
should be replaced every
2.5 years. The
HEPA Filter
should be replaced every 3 years.
REPLACING FILTERS
