8
9
sharkclean .com
1
Place the floor nozzle on a level surface.
2
Align the detachable canister over the
tube on the floor nozzle. Lower the
canister onto the floor nozzle until it clicks
securely into place.
(Fig. 8)
When attaching the motorized floor
nozzle, ensure that the latching
mechanism is fully locked in place to
ensure electrical connection has been
made.
3
Insert the wand into the tube on the back
of the canister, pressing until it clicks
securely into place.
(Fig. 9)
4
Align the tab in the accessory holder
(a)
with the groove in the wand, then slide
the holder down over the wand.
(Fig. 10)
5
Push the handle
(b)
onto the top of the
wand until it clicks into place.
(Fig. 10)
6
Insert the end of the stretch hose
(c)
into
the connector on the back of the canister.
(Fig. 10)
7
Store the dusting brush
(d)
and the
crevice tool
(e)
on the mounts of the
accessory holder.
(Fig. 10)
Fig. 8
Fig. 9
Fig. 10
a
b
c
Upper
Cord
Clip
d
e
POWER CORD:
1
Rotate the upper cord clip to quickly
release the power cord.
2
Secure the power cord by wrapping it
around the cord clips
(a)
.
(Fig. 11)
SETTINGS:
= Brushroll ON
= Bare Floor
= OFF
1
Press the Selector switch
(b)
to Setting
I to vacuum bare floors (straight suction
only) or to Setting II to engage the
brushroll (for vacuuming carpets and
rugs).
(Fig. 11)
BRUSHROLL INDICATOR LIGHT:
1
The brushroll indicator light
(c)
will
illuminate green when the brushroll is on,
or red if there is a blockage or jam.
(Fig. 11)
This feature is designed to
protect your Lifetime Belt that powers
your brushroll. See Checking for
Blockages on page 15.
2
To activate the brushroll, step lightly on
the floor nozzle, then tilt the handle back.
(Fig. 12)
NOTE:
The brushroll will not spin unless
the nozzle is flat against the floor and the
handle is tilted back.
3
Increase or decrease suction power by
adjusting the suction release collar
(d)
on the handle.
(Fig. 11)
If the vacuum
seems difficult to push or pull, or if it is
lifting up area rugs, reduce suction by
rotating the collar counterclockwise. To
increase suction and to vacuum floors,
rotate the collar clockwise.
4
Empty dust cup after vacuuming and
periodically during use when it appears
full. (See Maintenance section for
instructions.)
5
When you are finished vacuuming, move
the switch to the Off position.
Fig. 12
Fig. 11
c
Upper
Cord
Clip
Suction
Release Collar
d
a
b
Adjust the
suction release
collar to
reduce suction
for easier push
and pull on
thick carpets
and area rugs.
ASSEMBLING YOUR VACUUM
