15
sharkclean .co.uk
14
sharkclean .co.uk
FLOOR NOZZLE
MAINTAINING YOUR VACUUM
CLEANING SOFT ROLLER
FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug� If some fibres remain wrapped around the brushroll after continued
use, carefully remove them� If you run over a hard or sharp object or notice a noise change while vacuuming,
check for blockages by following the steps under ‘Checking for Blockages in the Floor Nozzle’ on the bottom
right of this page�
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld Vacuum:
1.
Turn off vacuum�
2.
Remove the handheld vacuum from the wand�
3.
Check all intake openings on the dust cup and remove
any debris or blockage�
Checking for Blockages in the Wand:
Standard Wand:
1.
Turn off vacuum�
2.
Remove the handheld
vacuum and floor nozzle�
3.
Check intake openings for
blockages and debris�
4.
Clear away debris and
blockages�
Flexology® Wand:
1.
Turn off vacuum�
2.
Remove the handheld
vacuum and floor nozzle
from the wand�
3.
Check the
Clog Access
Hose
on the Flexology
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out�
4.
Clear any debris and
blockages�
Checking for Blockages in the Floor Nozzle:
1.
Turn off vacuum�
2.
Detach the wand�
3.
Use the edge of a coin to open the three locks on the
bottom of the floor nozzle�
4.
Remove the cover and tilt back the neck of the floor
nozzle�
5.
Check the opening and remove any debris�
6.
Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides before turning the locks
clockwise to close, until they click securely into place�
1
To remove Soft Roller from nozzle, pull the Soft Roller out by
the tab�
2
Tap loose debris off the Soft Roller� Use a dry towel to wipe
the Soft Roller clean and to remove any debris caught in the
teeth behind the Soft Roller�
3
Hand wash the Soft Roller as needed� Use only water, and let
air-dry completely, which should take at least 24 hours�
4
Reinsert the Soft Roller�
