OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS cont.
Emptying the Dust Cup Container
and Cleaning / Changing the
HEPA Filter & Debris Screen
WARNING:
Always remove the power
plug from the wall outlet before
assembling or removing accessories.
INSERTING THE TELESCOPIC
TUBE INTO THE MAIN UNIT
• Insert the telescopic tube into the hole
next to the dust cup handle. Make sure
that the slot in the handle fits correctly
into the opening. (See illustration.)
• To remove the telescopic tube, press
the telescopic tube release button and
pull the tube up.
EXTENDING THE TELESCOPIC
TUBE
Push the plastic button and pull out the
smaller tube. See illustration below
.
ATTACHING THE FLOOR BRUSH
TO THE MAIN UNIT
• Insert the floor brush into its location,
in the direction of the arrow.
• To remove the floor brush from the
main unit, press on the floor brush
release button and pull the floor brush
out.
ATTACHING THE HOSE TO THE
MAIN UNIT
• Hold the end of the hose (see
illustration below).
• Insert the hose into the hose
connector (see arrow in illustration).
6. Reinstall the HEPA filter in the
vacuum.
7. To Separate the Debris Screen from
the dust cup, hold the dust cup in
one hand and turn the dust cup
cover counter clockwise and pull
apart. To clean the Debris
Screen, we
recommend that
you rinse it under
lukewarm running
water to remove
the dirt that
accumulates
on it, but always
allow 24 hours to air dry before
inserting back into the vacuum.
3. The HEPA filter is located underneath
the dust cup container. (See
illustration.) to remove the HEPA filter,
hold the edges and pull it out slowly.
2. To empty the dust
cup container,
press on the trap
door release button
that is on the back
side of the dust cup
container.
Warning:
Always unplug the
unit from electrical outlet before
opening the Dust Cup (container).
Important:
Do
NOT
use the vacuum
without the HEPA filter in place.
Warning
:
After each Use -
Always remove the HEPA Filter
and the Dust Cup Cover with
the Debris Screen, then
vigorously “
TapClean
” HEPA
Filter and clean Debris Screen
until no more dust can be
removed.
IMPORTANT, Please Note :
The
“TapClean” HEPA Filter will stop most of
the tiniest dust particles and airborne
allergens from re-entering the air you
breathe. In fact it stops 99.97% of all
particles as small as 0.3 microns - many
times smaller than a human hair!!!
Because of this incredible filtration
performance, the HEPA Filter will quickly
accumulate, inside the white filter folds,
many fine dust particles that are difficult to
see but which will eventually block or
reduce your suction power - if not cleaned
properly.
5. Hold the HEPA filter
by the edges and
vigorously “TapClean”
the HEPA Filter
dirty
side down
on a hard,
flat surface until no
more dust is observed
falling out from
between the pleats of
the filter.
1. To remove the dust cup container,
first press on the dust cup release
button (1) that is located on the dust
cup handle and at the same time
press on the dust cup release button
(2) that is on the side of the upper
housing. See illustration below. Then
pull the dust cup container out.
Dust
Cup
Release
Button 2
Dust
Cup
Release
Button 1
7
4
