Shark Anti Hair Wrap & DuoClean with Powered Lift-Away ICZ160UK Series, Инструкция по эксплуатации

Страница: 10 / 13

TROUBLESHOOTING TROUBLESHOOTING
Vacuum is not picking up debris.
No suction or light suction.
•
Ensure handle, hose, dust cup, and wand
are all securely connected onto the unit.
• Check filters to see if they need cleaning.
Follow instructions for rinsing and
completely air-drying the filters before
reinserting them in the vacuum.
• Dust cup may be full; empty dust cup.
• Check wand, hose, hose connections,
nozzle and accessories for blockages;
clear blockages if required.
• Check floor nozzle for blockages;
clear blockages if required.
• Remove any string, carpet fibres, or hair
that may be wrapped around the brush-roll
and Soft Roller or trapped behind the
Soft Roller.
Vacuum lifts rugs.
• Turn off vacuum, and move it away from
any obstruction. Turn on vacuum and tilt
handle back to activate brush-roll.
• Check that vacuum is in Extended Runtime
mode and/or try Floor mode.
• Turn off the unit to disengage the brush-
roll and restart with the Power button.
Brush-roll/Soft Roller does not spin.
• If Brush-roll Indicator Light on the floor
nozzle turns red, the brush-roll and/or
Soft Roller have stopped spinning.
Immediately turn off and remove battery
from vacuum pod and remove blockage
before reconnecting and turning vacuum
back on. If light turns green, the blockage
has been successfully cleared.
• If headlights are not illuminated, there is
a connection issue between the hose, pod,
wand, and nozzle. Try disconnecting the
pieces and then reconnecting them,
sliding in each one until it clicks securely
into place.
Vacuum turns off on its own or
will not turn on.
There are several possible reasons for
the vacuum cleaner turning off on its own,
including blockages, battery issues, and
overheating. If the vacuum cleaner turns
off on its own, perform the following steps:
1. Check battery indicator lights to see if
battery needs to be recharged. If it does
not need charging, turn off the vacuum
cleaner and remove battery.
2.
Empty dust cup and clean filters.
3.
Check wand, accessories, and inlet
openings and remove any blockages.
4. Allow unit and battery to cool for at
least 45 minutes, until it returns to room
temperature.
5.
Return battery to vacuum and press
Power button.
Dust cup will not latch onto unit:
• The dust cup will not latch if the pod is not
inserted properly onto the unit. Align the
bottom of pod onto the rails on the front
of the neck of the floor nozzle. Slide pod
down the rails until it clicks into place.
Battery not charging.
• Batteries outside of optimal temperature
range may not begin charging immediately.
Move to room temperature area and/or
allow battery to cool before charging.
• Please review battery runtimes in the
Operating the Vacuum section.
• When charging with the cradle, ensure
battery is pressed all the way down onto
cradle and that charge indicator lights
illuminate.
• Battery life expectancy is at least two
years and comes with a two-year limited
guarantee. New battery packs can be
purchased at sharkclean.eu
• When charging with the cradle ensure the
charger is inserted and then rotated to lock
it into place. Battery will not charge unless
the charger is locked into place.
Battery not inserting into vacuum.
• Make sure handle is down before pushing
battery securely into place.
• Make sure Post-Motor Filter filter is securely
clicked into place prior to inserting the
battery.
LIGHT INDICATOR WHAT IT MEANS
FLOOR and CARPET LEDs flash
together
Blockage detected. Turn off
unit and remove blockage.
BOOST LED flashes
Unit temperature is high.
Turn off vacuum and wait
for approx. 45 minutes.
While unit is cooling, look for
blockages and remove any
that are found. Filters may
also need to be cleaned.
See Maintenance Section.
FIRST and THIRD BATTERY
INDICATOR LEDS flash alternately
Battery temperature is
not optimal, so charging is
temporarily paused. Leave
battery plugged in and
charging will resume soon.
BATTERY REMOVAL AND DISPOSAL
This product uses a lithium-ion rechargeable and recyclable battery. When the battery no longer holds a charge, it should
be removed from the vacuum and recycled. DO NOT incinerate or compost the battery.
When your lithium-ion battery needs to be replaced, dispose of it or recycle it in accordance with local ordinances or regulations.
In some areas, it is illegal to place spent lithium-ion batteries in the bin or in a municipal solid waste stream. Return spent battery
to an authorised recycling centre or to retailer for recycling. Contact your local recycling centre for information on where to drop
off the spent battery.
19
sharkclean .eu
18
sharkclean .eu