SHAREBOT Next Generation, Руководство пользователя

Страница: 29 / 66

29
Preparting the printing bed
We remove the clothespins from the glass and extract it from the printer. Sprinkle over a thin layer
of spray evenly up to cover the entire surface (light you will have a shiny effect). Now we await the
complete lacquer drying and glass are placed on printing and secure it with pegs. Never spray inside
the printer because it means severely damage the mechanical movements of the same and con-
sequently invalidate the warranty. After a series of prints or when the dish will have bumps or dirt
residues dates of previous prints, estraerete the glass to wash it in lukewarm water in order to report
the conditions under which it was when you bought the printer. Always pay attention when moved
the glass plate.
Reposition the glass printing bed in the printer, with 2 clothespins block it as in figure below. The
position of the pegs is not binding or final: pegs in blocking the glass invade useful print area, you
can then change the position based on which in turn will be printed, so as not to find the clamp on
the nozzle.
Learning to set up the plate
This, though initially a bit laborious, will become for you a habit that you do before every printing
quality, without this there commitments for more than a few seconds. With the experience you will
be able to take action during the printing of the first layer in case you highlight any irregularities in
thickness. In general, acquire the right to adjust the sensitivity of the press, even just looking at the
front and at the floor and the extruder, it will be for you an advantage and potential always prints
guarantee optimal.