SHANY MZC-81XX SERIES, Руководство пользователя

Страница: 25 / 38

Installation / User’s Guide
24
2. Speed Dome Camera Address Setting
The address code (Cam ID) for the speed dome must to be properly set before use to
ensure accurate addressing of the domes for control at center. The address code is made up
of SW201 (8-bits) dip switch on PCB board. The 8-bit switch uses the 8421 binary coded
decimal system; the largest value is 256. “1” means ON status and “0” means OFF status.
Each dome address code (Cam ID) that display at keyboard or control devices is response
to the settings shoeing in the chart below: (see the following figure and the address/digits in
following chart)
Note
1. When all switches at “OFF” the address code of speed dome is 1.
2. When you input 1 + Cam at control keyboard (MCU-PTZ091), the keyboard
(MCU-PTZ091) should communicate with the speed dome to control.
3. Other addresses , please refer to the table above for settling reference.
4. Please note the Cam ID address for PELCO-D and PELCO-P protocol modes are
different. Please check the system protocol type before making the Camera ID setting.
5. Cable pin out assignment
Color Function
Video Out
Red AC 24V / DC 24V
Blue AC 24V / DC GND
Yellow RX+
Orange RX-
Gray TX+
Green TX-