User’s Guide
HRT 65-125
-
16
-
hs
Tensioning and changing filament
9
9.3
CHANGING THE FILAMENT
1.
Turn the filament to the lowest position.
2.
Unscrew the socket head screw in the wire pon on the
right. (Use socket screw key
No. 1
½
).
3.
On the left side, slide the expanding pin with the spring
out of the pin block.
4.
Slide the spring off the expanding pin.
5.
Unscrew the expanding pin from the connection screw
(incl. connection wire).
6.
Remove the filament from the expanding pin and the wire pin.
7.
Slide a new filament into the expanding pin, and make
sure that the eye is pulled well into the pin.
8.
Screw the expanding pin onto the connection wire (incl.
connection wire), and attach firmly.
Take care not to damage the expanding pin. Tightening firmly by hand is
sufficient.
9.
Slide the spring over the filament, and slide the filament through to the
expanding pin.
10.
Slide the filament, with expanding pin, through the white insulation
sleeve of the pin block, and pull it through as far as possible.
2
5
Connection wire
Expanding pin
7
Eye
Pin block
