User’s Guide
HRT 65-125
-
9
-
hs
Operation
6.1
PREPARATION
1.
Clear the working surface.
2.
Check that all the heating elements are connected to the control units.
3.
Check that no scraps of material remain in the reflectors.
6.2
SWITCHING ON HEATING ELEMENTS
Each heating element can be switched on and controlled individually.
Switch on the control unit with switch
H
.
6.3
SETTING TEMPERATURE
The temperature of the filament can be set using the temperature control.
1.
When turning on the on/off switch, the display will show the value that
was last saved (keeping the machine on a certain value for >20
seconds will make it remember this value).
2.
Press the right button (arrow up) to increase the value, up to 99
(keeping this pressed in will make the value cycle much faster)
3.
Press the left button (arrow down) to decrease the value, down to 00
(keeping this pressed in will make the value cycle much faster)
4.
Press both buttons at the same time to go directly to 00. Doing this also
resets the machine.
6
