Shad UC02, Инструкция по эксплуатации, Страница: 20 / 26

The Shad HANDSFREE is very easy to install into a helmet. Remove the side padding from the inside of the helmet (if it can be
removed) and place the handsets (2) and (3) at the height of your ears. The device is designed so that the main unit with the boom
microphone is placed on the left side. The wire between handset (2) and (3) must be stored inside the helmet, under the padding. In
order to fix the headphones, two velcro pads are provided (male and female) with an adhesive backing (7). In case you need to use the
velcro, stick the male part of the pad onto the device and the female part onto the inside of the helmet.
Depending on the internal configuration of each type of helmet, it may be necessary to use the entire velcro pad or only a part of it (see
figure 2). In some cases, it may only be necessary to stick the male part onto the device as the inside of the helmet may have padding
that can serve as velcro (female).
If needed, comfort pads (6) to place on the headphones are also provided, in order to improve comfort against your skin.
Place the microphone (1) on the front section of the helmet close to and oriented towards your mouth.
3
1 2
4
0% 100%
Before using your Shad HANDSFREE device for the first time, you must charge the device completely.
Connect the terminal (1c) to the provided USB charging cable (4) and then connect the cable to a USB charging port.
While charging, the red LED light will switch on (1a) and it will change to blue once charging has been completed.
NOTE : Don’t pull on the cable to disconnect it from the USB port.
NOTE : As time goes by, batteries gradually lose their charge. This is why it’s important to charge the battery fully before using the device
and allow the battery to use almost all of it’s charge in between charging cycles.
NOTE: To ensure proper function, do not operate the Shad HANDSFREE device while charging.
WARNING: If you plan to store your Shad device for a long period of time, be sure to recharge it at least once every six months to
ensure perfect battery performance
.
Installation
Charging
2