PAGE 13
PAGE 12
1. Put the cover off first and put on the breath pipe and air filter before
the compressor run.
2. Never unscrew any connecting part when the tank is in pressure condi-
tion.
3. Never disassemble any electrical part before disconnecting the plug.
4. Never adjust the safety valve carelessly.
5. Never use the compressor in place where voltage is too low or too high.
6. Never disconnect the plug to stop compressor, set the switch knob in
position off instead.
7. If the release valve doesn’t work as motor stopped, find the cause im-
mediately so as not to damage motor.
8. Lubricating oil must be clean, oil level should be kept in the score of oil
ruler.
9. Disconnect the plug to cut off power supply and open the outlet valve
CAUTIONS
MAINTENANCE
CLEAN THE AIR FILTERS (MONTHLY)
The air filters must be examined monthly and more often in dusty condi-
tions:
1. Unscrew the filters from the compressor.
2. Remove the filter covers from the filters.
3. Clean the sponge and the filter cover using a soft brush. If necessary,
the filters can be carefully cleaned in warm soapy water. Rinse and let
the filters dry completely before refitting.
4. Make sure that the filters and filter covers are replaced into position. If
the filters are damaged, you must replace them.
CLEANING
1. Clean crankcase and renew lubricating oil after the first 10 working hours.
2. Clean the oil level after every 20 working hours, and replenish if neces-
sary.
3. Open drain cock under the tank toexhaust condensate after every 60
working hours.
4. Clean crankcase and renew the oil, clean air filter, and check safety valve
and pressure gauge after every 120 working hours.
WWW.SGS-ENGINEERING.COM
