18
SET DMX ADR
10
NEXT FIX
13
Configuring the device for DMX control
Setting the DMX address
The DMX address can be seen on the main screen. To change the address
setting, press the up arrow to increase the address, or the down arrow to
decrease the setting. When the desired address is displayed, press Enter to save
the setting. For your convenience, the suggested DMX address of the next fixture
is displayed to the right. Note that channel spacing is determined by the DMX
mode.
See the “DMX protocols” on page
22 for specific DMX control values.
About DMX
The Q-7 can be controlled using signals sent by a DMX controller on a number of channels (which varies depending on
the DMX mode that has been set).
The first channel used to receive data from a DMX control device is known as the DMX start address. Each Q-7 must
have a DMX start address set. For example, if a Q-7 has a DMX address of 10 and it is in 4-channel DMX mode, then it
uses channels 10, 11, 12 and 13. The following fixture in the DMX chain could then be set to a DMX address of 14. If
two or more DMX devices of the same type have the same DMX address, then they will mimic each other’s behavior.
Incorrect settings will result in unpredictable responses to the lighting controller.
Manual_Q7-Q7W_Rev.2_170x113,3.book Page 18 Thursday, May 22, 2014 12:38 PM
Содержание Q?7
Страница 1: ...Q 7 Q 7 WHITE Manual_Q7 Q7W_Rev 2_170x113 3 book Page 1 Thursday May 22 2014 12 38 PM...
Страница 37: ...37 User s notes Manual_Q7 Q7W_Rev 2_170x113 3 book Page 37 Thursday May 22 2014 12 38 PM...
Страница 38: ...38 Manual_Q7 Q7W_Rev 2_170x113 3 book Page 38 Thursday May 22 2014 12 38 PM...
Страница 39: ...39 Manual_Q7 Q7W_Rev 2_170x113 3 book Page 39 Thursday May 22 2014 12 38 PM...