GB
SGM Technology for lighting
Palco Series
- 29 -
User’s Manual 1.03
T
IME
It’s just as important to set Palco’s on-board clock if it has to be used later in Stand-alone mode.
1.
Use the UP/DOWN keys to find the “C” (Clock) menu
2.
Press “Enter” to confirm the choice. The first two numbers (relative to
the hours) will begin to flash on the display.
3.
Use the UP/DOWN keys to select the current time (the hour – from 00
to 23).
4.
Press “Enter” to move the setting from the hours to the minutes
5.
Use the UP/DOWN keys to select the current time (the minutes – from
00 to 59).
6.
Press “Enter” to move the setting from the minutes to the seconds
7.
Use the UP/DOWN keys to select the current time (the seconds – from
00 to 59).
8.
hold “Enter” pressed down for approx. 6sec. to confirm the new time
S
ETTING DEFAULT PARAMETERS
This enables to set the default parameters
1.
Use the UP/DOWN keys to find the “FACT” menu
2.
Press “Enter” to confirm the choice. The text on the display will begin to
flash.
3.
Use the UP/DOWN keys to select ”FACT=SET” and press “Enter”
4.
Press “Enter” to set the default parameters shown in the table.
“FACT=OFF” appears on the display.
P
ALCO
3 P
ALCO
5 M
ENU ITEM
D
EFAULT PARAMETER
X
X
ADDR
001
X
X
BRIGHT
40%
X
X
DMXDLY
UNL
X
BOOST
OFF
X
WIRELS
OFF
X
W_EXIT
OFF
R
ESETTING DEFAULT PARAMETERS
This enables to reset the parameter values set immediately before the FACT=SET operation. In other
words, if the default parameters have been set by mistake, this operation allows to revert to the values
set previously.
1.
Use the UP/DOWN keys to find the “Prev” menu
2.
Press “Enter” and hold it down for a few seconds to confirm the choice.
The text on the display will begin to flash.
3.
Use the UP/DOWN keys to select ”PREV=SET”
4.
Pressing “Enter” in this mode resets the values, cancelling the FACTORY
DEFAULT operation. In the meanwhile, PREV stops flashing and the
message that appears is PREV=OFF
PREV=OFF
PREV=SET
FACT=OFF
FACT=SET
C 12:06:20
