SGM Technology for lighting
GB
User Manual 1.00
Genio Mobile
- 40 -
5
O
PERATING THE FIXTURE
5.1
White Balancing
Genio Mobile is fitted with a white balancing system that can be customized and stored for each fixture for
an unlimited number of times. Moreover, in the context of any balance which is set, it’s possible also
possible to adjust colour temperature in a completely dynamic manner according to needs, by means of the
CTC channel, with a certain range round the balanced white or Full Colour value.
All these operations can be carried out via DMX, or directly on the fixture itself. Should it be necessary to
balance the white via DMX, proceed as follows:
1.
Set the Color_Mode channel at 220 (85%)
2.
Use the RED, GREEN and BLUE channels to obtain the required white balance
3.
Set the Macro channel at 71 (28%)
4.
Increase Color_Mode to the maximum - 255 (100 %). After 4 seconds, the new white balance is
stored by the Genio Mobile
The Color Mode channel can also be used as an instant selector between: previously stored balance (at the
value of 127) or Full-color Power (at the value of 0) when total colour emission is required, without any
limits being set by the balance.
5.2
Colour Temperature Control (CTC Channel)
The CTC channel allows to adjust the fixture’s color temperature by means of channel 6 of Genio Mobile. It
acts in a range around the white balance or Full-Color, according to requirements. It’s therefore possible to
cool down or warm up in a linear manner absolutely any type of previously chosen white, by more or less
2000 K°.
To enable the Colour Temperature Control related to a custom white balance, bring the channel 8, Colour
Mode, to the DMX value 127 (50%). On the other hand, the CTC channel will adjust the colour temperature
based on the natural white NOT BALANCED of Genio Mobile, should the channel 8 be set at DMX=000.
5.3
Infrared (IR) use
Genio Mobile can also be used through its remote IR control when the DMX line is not connected to the
fixture. The IR signal will be automatically detected, without performing any particular setting, when the
remote IR control will be aimed to the fixture, allowing the control the following features:
Colour adjustment (Red, Green, Blue)
Pan and Tilt positioning
Running Macros
Enabling Programs
Enabling Scenes
Storing Scenes
Enabling the Master mode
Enabling the internal Scheduler
