GB
SGM Technology for lighting
Genio Mobile
User Manual 1.00
- 17 -
2.7
Wall mounting
1.
Perform 2 holes into the wall at a distance of 165,5 mm and insert two wall screw plug M6
2.
Insert but not tighten two HEX screws M6 and washers into the wall plugs, paying attention to leave
about 6mm gap across the head of the screw and the wall surface.
3.
Install the bracket on the bottom of the fixture by means of the 4 screws supplied as standard along
with the fixture.
4.
Place the fixture beside the screws fitted in the wall in such a way that the head of the screws are in
front of the holes located on the handle fixing plate.
5.
Slide the fixture towards the screws
6.
Tighten the screws by using a metric wrench size 10. (see the above picture for your reference)
7.
Pull the safety-chain through the holes on the bottom of the base and over the trussing system or a
safe fixation spot.
8.
Insert the end in the carabine and tighten the safety screw.
The installation of the fixture has to be built and constructed in a way that it can hold 10
times the weight for 1 hour without any harming deformation.
Overhead mounting requires extensive experience, including amongst others calculating working
load limits, installation material being used, and periodic safety inspection of all installation material
and the device. If you lack these qualifications, do not attempt the installation yourself. Improper
installation can result in bodily injury.
The fixture should be installed outside areas where persons may reach it, walk by or be seated
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety cable.
Never stand directly below the device when mounting, removing or servicing the fixture.
The operator has to make sure the safety relating and machine technical installations are approved
by an expert before taking the device into operation for the first time.
These installations have to be approved by a skilled person once a year.
Safety Chain
