SGM G-7 SPOT, Руководство пользователя

Страница: 13 / 44

13
Product Version 1.0 | Revision E | Released 2023-01-11
Max. 32 units/DMX line
1 2 xx
100 - 277V AC
50-60 Hz
500 W
100 - 277V AC
50-60 Hz
500 W
100 - 277V AC
50-60 Hz
500 W
DMX Termination
on last fixture DMX ou
t
DATA
GND
DATA -
DATA +
120 Ohm +/- 5%
Max. 6 units/16 A circuit
CONNECTING POWER
The power cable color coding is given in figure 7:
• Connect the black wire to live.
• Connect the white wire to neutral.
• Connect the green / yellow wire to ground (earth).
For an outdoor installation, the mains cable must be fitted with a grounded connector intended for exterior use.
After connecting the G-7 Spot to power, run the on-board test by selecting TEST → AUTOMATED TEST in the menu to
ensure that the fixture is functioning correctly.
CAUTION!
DO NOT CONNECT THE FIXTURE TO AN ELECTRICAL DIMMER SYSTEM AS DOING SO MAY
CAUSE DAMAGE.
CONNECTING DATA
The G-7 Spot is controllable by a DMX control device, and can be connected by either a DMX cable or via the fixture’s
built-in CRMX wireless receiver system. This system is compatible with Lumenradio 2.4GHz systems.
When using a cabled DMX system, connect the DMX-In cable to the input connector and DMX-Out cable to the
output, both on the rear of the fixture’s base (chassis mounted male and female 5-pin XLR plugs). For outdoor
installations, use only IP-rated XLR connectors suitable for outdoor use. Terminate the DMX out cable of the last
fixture in the data link with a 120 ohm DMX termination.
Note that SGM fixtures provide a passive DMX Thru signal as DMX Out, instead of an active output signal.
The fixture must be grounded/
earthed and be able to be isolated
from AC power. The AC power
supply must incorporate a fuse or
curcuit breaker for fault protection.
Color
Black
White
green/yellow
Conductor
live
neutral
ground (earth)
Symbol
or
L
N
Wire
Figure 7: Connecting AC Power
Figure 8: Connecting DMX in G-7 Spot