Page 17 of 24
Press
to confirm, the display will be as shown here next.
press the
key to exit and confirm the selection; press the
key to exit and
delete the selection.
8.7.2.3.3 -
Pulsewidth (ms)
Sets the pulse width in ms.
Default: 000.0;
Range: 0000.0÷1000.0
Press the
key from run mode: the display will be as shown here next.
With
or
change the digit, with
moves the cursor.
Press
to confirm, the display will be as shown here next.
press the
key to exit and confirm the selection; press the
key to exit and
delete the selection.
8.7.2.3.4 -
Pulse Level
Sets the pulse output energy level. When set LOW the pulse count is low, when set
HIGH, the pulse count is high.
Default: Active L (LOW); Range: Active L (LOW) ÷ Active H (HIGH)
Press the
key from run mode: the display will be as shown here next.
With
or
select the parameter setting.
Press
to confirm, the display will be as shown here next.
press the
key to exit and confirm the selection; press the
key to exit and
delete the selection.
8.7.2.4 -
RS485 Output
Press the
key to enter the submenu “RS485 Output” .
8.7.2.4.1 -
RS Protocol
Sets the RS485 output communication protocol.
Default: MOD-BUS RTU
Range: MOD-BUS RTU ÷ MOD-BUS ASC
Press the
key from run mode: the display will be as shown here next.
With
or
select the parameter setting.
Press
to confirm, the display will be as shown here next.
press the
key to exit and confirm the selection; press the
key to exit and
delete the selection.
8.7.2.4.2 -
Baud Rate
Sets the RS485 output Baud Rate.
Default: 9600
Range: 1200 - 2400 - 4800 - 9600
Pmag
- Setting
