SGL Rotary "pod", Руководство по эксплуатации и обслуживанию

Страница: 12 / 28

Once the self-learning function is activated, dose settings for 'short' coffee / 'long' coffee /
soluble selections' can be modified by following these programming steps: Switch on the
machine, make sure there is water in the tank, and get the machine ready for use. Before
programming doses, wait at least 5 minutes after the machine is switched on. Insert a pod
into the pod holder, close the lid and press button 10 11 or 12. Hold it down until the desired
dose is obtained. After five seconds the (green and red) LEDs of indicator light 9 start flashing
alternately, thus signalling that programming is in progress. Once the desired dose is
obtained, release the button. Only the green LED will be on, signalling programming is over.
Wait a couple of seconds and proceed to program another coffee option. (Repeat these
adjustments until you obtain the desired doses). It is advisable to carry out a final checking of
the doses set.
This appliance is delivered from the factory with default doses.
DRAWER AND LID SAFETY FUNCTIONS
The lid to insert pods has two safety devices, an electrical one and a mechanical one, that
do not allow machine regular operation when the lid is open.
Electrical safety device prevents rotation of the pod holder, condition that is signalled
(flashing red LED) simply after pressing the dispensing button to obtain the desired amount,
whereas the mechanical device does not allow opening the lid during dispensing.
If during dispensing, the drawer is removed, such dispensing is interrupted immediately.
Upon closing the drawer, the machine cancels the dispensing cycle in progress.
CLEANING AND MAINTENANCE
CLEANING AFTER USE (FIG. Q)
Before starting any cleaning operation, unplug the plug from the power socket. NEVER
IMMERSE THE MACHINE IN WATER.
- Clean with a cloth damped with water and dry thoroughly.
- Always place the machine on degreased and dry surfaces.
- Remove grid 6, take out and empty drawer/pan 5 / 7.
- Slide off the milk-frothing wand 4 (operation to carry out after each cappuccino) with a light
downward push.
- In the case the pipe 3 were clogged, being really careful, it is possible to act on the
dispensing hole with a needle in order to clean it.
- The pod holder can be cleaned carrying out an empty coffee cycle, see 'Coffee
preparation' section.
- Wash every removed part with hot water and kitchenware detergent. Dry thoroughly and
refit them.
PROLONGED MACHINE INACTIVITY
If the appliance is not going to be used for a long time, it is advisable to:
- Turn it off and disconnect all electric;
- Empty the water tank.
It is also advisable to turn off the appliance every day, when it is not used, so as to save
energy. As a matter of fact, when the appliance is turned on again, it rapidly reaches its ideal
operating temperature (approx. 2/3 minutes).
DROPS COLLECTION PAN CLEANING (figure Q)
Pan 7 has to be rinsed thoroughly in order to remove coffee scales. It can be washed with
hot water and dishes liquid detergent or specific washing powder in order to eliminate
coffee scales.
11
English