25
2) Carefully remove the elevator from
one of the horizontal stabilizer panels.
Note the position of the hinges.
3) Remove each hinge from the horizon-
tal stabilizer panel and elevator and place
a T-pin in the center of each hinge.Epoxy
the wire elevator joiner into the pre-
drilled elevator halves.
4) ) Slide each hinge into the elevator un-
til the T-pin is snug against the elevator.
This will help ensure an equal amount of
hinge is on either side of the hinge line
when the elevator is mounted to the hori-
zontal stabilizer panel.
Glue the hinge hinges in place using the
same techniques used to hing the ailerons.
INSTALL ELEVATOR CONTROL HORN.
Epoxy.
Elevator fiberglass control horn.
Epoxy.
Fiberglass control horn
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
2) Using a modeling knife, carefully re-
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
Draw center line
