iono solo
iono solo doesn’t ship with a pre-installed sketch, for the simple reason that there is no
Arduino module installed!
Still, before installing your own Arduino board, you should check that it powers-up
normally.
1. connect iono to a regulated power source (check the data sheet for the power
requirements)
2. gently remove the side cover on the inputs side
3. check that the LD1 power LED, next to the power supply terminals, is on
4. remove the power supply
5. gently remove the side cover on the outputs side
6. install your Arduino board
7. reconnect the power supply and check that LD1 goes back on.
9
Hardware Guide
